RTS Cstrunk Especificaciones descargar pdf (Pagina 98)

RVON Serial and Telnet Commands

RVON card programming can be done via direct serial or telnet connection. There are several physical connections to an

RVON board:

• Direct serial through custom debug cable (J20 6-pin bottom front)

The customer debug cable always functions as the general-purpose debug tool.

• Backcard DB-9 J2

The backcard DB-(must be disabled/enabled via a DIP Switch because it can also be used for serial port pass-

through. The backcard DB-9 can be used for a debug terminal when DIP switch 6 is switched to the ON position.

• Backcard RJ-45 J1 (Telnet Only)

Setup

Serial Port 38,4000 baud, No-flow control

Telnet IP Address, port 23

How to Configure the RVON-1 using Telnet

Without access to the physical KP-32 Family with RVON-1 installed on it, you can still configure the card through the use of

Telnet. The following instructions will show you how to access the Telnet screen and show you some of the information you

can see and edit.

NOTE: These instructions are to help you get to the Telnet screens and give you an overview of what can be done. This is

NOT an all inclusive document. Not every action that can be performed are contained within the document.

To display the settings for the RVON-1 Card, do the following:

1. Open a command prompt.

2. At the prompt, type Telnet <IP ADDRESS> (The IP Address is the IP Address assigned to the RVON-1 card).

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 104

Sin comentarios

RTS Cstrunk Especificaciones Pagina 98