RTS Cstrunk Especificaciones Pagina 30
- Pagina / 104
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
24
Display Listen Key Assignments
FUNC DISPLAY 3
This sequence displays all listen key assignments for about 10 seconds. Lstn displays in the call waiting window.
> Tap CLR to quit.
Display Setup Page Assignments
FUNC DISPLAY E-PNL
Currently, there are four setup pages available for each keypanel. Each setup page defines a set of 16 talk and listen key
assignments. Most RTS keypanels have a maximum of 16 keys, so one setup page is typically assigned to the main keypanel,
and is referred to as the Main setup page. Additional setup pages are assigned to any connected expansion panels, and are
referred to as Expansion 1, Expansion 2, etc.). Since the KP-632 requires 2 setup pages, it uses the main page assignments and
also one expansion page (Figure 8). The EKP-632 uses two additional expansion pages.
When you enter the sequence FUNC DISPLAY E-PNL, the call waiting window displays Mn-1 or Mn-2, etc. This indicates
which setup page is currently being used at the “Main” position. After a few moments X1-1, or X1-2, etc. displays. This
indicates which setup page is currently being used by expansion 1. Next, if there is an expansion panel connected, X2-1 or X2-
2, etc. displays, followed by X3-1 or X3-2, etc. to indicate the setup page usage for expansion 2 and expansion 3.
> Tap CLR to quit.
NOTE: To change the setup page assignments, see “Keypad Programming, Assigning Setup Pages” on page 26.
Test Keys and Displays
FUNC DISPLAY 0
When you enter this sequence, all alpha-numeric displays show a % symbol. Pressing down on any key (except the Headset /
Vol. Sel. key) will cause OK to display. This verifies operation of the key. Tapping up or down on the Headset / Vol. Sel. key
will cause the display to cycle through the available selections.
If latching is enabled, tapping up or down on any intercom key, or the Call waiting key, will cause the corresponding red LED
to light. This verifies latching operation and also that the each red LED is OK.
Holding any key in the up or down position will cause the corresponding green LED to light. This verifies operation of the
green LEDs.
> Tap CLR to quit.
FIGURE 8. Setup page usage for the KP-632 and EKP-632
- USER INSTRUCTIONS 1
- Contents 3
- Introduction 9
- GPI Connector Module 10
- EKP-632 Expansion Keypanel 11
- LCP-632 Level Control Panel 11
- MCP-90 Panel Microphone 12
- Headsets 12
- Installation 13
- Address Switch Setting 14
- Address Setting for Zeus 15
- Address Setting for ADAM CS 15
- Connections 16
- Power Supply Connector 17
- Headset Connector 17
- Panel Microphone Connector 18
- Basic Operation 19
- Intercom Keys and Displays 20
- Listen LED Indication 21
- Intercom Key Operation 22
- Muting the Microphone 23
- Call Waiting Operation 24
- Telephone Operation 25
- KP9X Redial Sequence 26
- KP9X Autodial Sequences 26
- Manual Dialing 27
- Autodial 28
- Display Panel ID 29
- > Tap CLR to quit 29
- 1. Tap the E-PNL key 32
- 3. Tap the PGM key 32
- • Tap COPY 35
- Clearing a Key Assignment 35
- KP-632 Menu System 37
- Menu System, Key Assign Menu 39
- Key Assign Menu, Matrix 40
- Key Assign Menu, Pt-to-Pt 40
- Key Assign Menu, Party Line 40
- Key Option Menu 43
- Key Option Menu, Key Groups 44
- Key Option Menu, Solo 44
- RVON Conn. Menu 45
- Service Menu 45
- Service Menu, Baud Rate 46
- Service Menu, Dim 46
- Service Menu, Disply Dim 46
- Service Menu, Hdst Sel 48
- Service Menu, LCD Bright 48
- Service Menu, Matrix Out 51
- Service Menu, Mic Select 51
- Service Menu, Min Volume 51
- Service Menu, Mod Assign 51
- Service Menu, Output Level 52
- Service Menu, Reset Cfg 53
- Service Menu, Save Cfg 53
- Service Menu, Scr Saver 53
- Service Menu, Sidetone 54
- Service Menu, Snoop Tally 54
- Service Menu, Test Panel 54
- Service Menu, Tone Gen 54
- Specifications 55
- Speaker Amplifier and Speaker 56
- KP9x Display Sequences 63
- KP9x Setup Page Assignment 64
- KP9x Phone Operation 65
- Menu Access 67
- Menu List 68
- Mode 2 Operation 69
- Glossary 71
- Features 77
- Dip Switches 79
- Addresses and the RVON-1 82
- Top Level Menu, Rvon Conn 84
- Basic Network Configuration 87
- Wide Area Network 89
- TABLE 4. Packet Translation 90
- TABLE 5. Packet Translation 90
- IP Addresses 92
- Ping a Computer 93
- RVON Configuration 95
- Network Terminology 96
- • Backcard DB-9 J2 98
- Press Enter 100
- 3. Press Enter 101
Relacionado con productos y manuales para Sistemas de intercomunicación de la puerta RTS Cstrunk
(72 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.038 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales