RTS Cstrunk Especificaciones descargar pdf (Pagina 82)

In the KP 812, the RVON-1 card connects to the KP 812 by way of the J2 connector on the RVON, attached to J37 on the KP

812 header.

3. Connect the RJ-45 extension connector cable to the RVON-1 board.

RVON-1 Relay

When connected to an Ethernet LAN, audio comes from the RVON-1 card; and, when Ethernet is not plugged in, the audio

comes from the AIO connection. Note, the user does not need to remove the RVON-1 to switch to AIO mode.

WARNING: You cannot have both an Ethernet connection and an AIO connection simultaneously. If the Ethernet and

AIO are connected simultaneously, no audio communication will occur.

Addresses and the RVON-1

Because the RVON-1 has an Ethernet interface, it is required to have a MAC (Media Access Control) Address. This is a low

level address that contains 48 bits. Do NOT confuse this address with an IP (Internet Protocol) Address. In order to be IP

compliant, all cards must have a unique MAC ID when shipped from the manufacturer. Typically, the MAC ID of a piece of

hardware, such as the RVON-1 card, has a fixed or static address. Where as the RVON-1 card’s IP Address can change over

time.

The MAC Address uniquely identifies each node of a network and interfaces directly with the network media. The RVON-1

card has a small 8-pin serial device on the board that the processor can read the unique MAC Address from. For more

information on MAC IDs, contact technical support.

NOTE: Each RVON-1 card needs to be programmed with its own IP Address.

FIGURE 13. The J37 connector on the KP 812 board.

J37

RJ-45

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 103 104

Sin comentarios

RTS Cstrunk Especificaciones Pagina 82