RTS Cstrunk Especificaciones descargar pdf (Pagina 16)

ADAM CS with 50-pin Telco Back Panel

Determine the address setting from Table 1 on page 9. To use the table, locate the intercom port number to which the KP-632

will be connected. Then, read across to the Address column to find the Address number. Set the KP-632 Address switch to this

number.

NOTE: Settings 0, and 9 through F are not used.

Address Setting for ADAM

Each Audio I/O card contains 1 group of 8 intercom ports. Determine the address setting from NOTE:. To use the table, locate

the intercom port number to which the KP-632 will be connected. Then, read across to the Address column to find the Address

number. Set the KP-632 Address switch to this number.

NOTE: Settings 0, and 9 through F are not used.

Connections

EXP. Connectors

Connect from the Exp. connector on the back of the KP-632 to the Expansion 1 connector of an optional EKP-632 Expansion

Panel. Use the interconnect cable supplied with the Expansion Panel.

Frame Connector

Use either of the Frame connectors (but not both) to connect to an intercom port of the intercom system. The intercom port you

connect to should agree with the address that you set previously. Cable wiring diagrams are shown in Figure 6 and Figure 7.

FIGURE 6. DE9S Intercom Cable Wiring

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 103 104

Sin comentarios

RTS Cstrunk Especificaciones Pagina 16