
75
Installation of the RVON-1 Card in a KP 812
To install the RVON-1 card, do the following:
1. Remove the cover from the KP 812 keypanel.
NOTE: It is recommended to seat the RVON-1 card on the J2 connector located on the KP 812
motherboard before snapping the RVON-1 board onto the spacers. Be careful to attach J2 to J37
correctly.
2. Gently secure the RVON-1 board in place.
NOTE: Be sure the orientation of the board is correct, otherwise undesirable effects may occur. Make sure
the RJ-45 connection is positioned so it will connect correctly to the RJ-45 connector:
FIGURE 11. Spacer placement on KP 812 motherboard
FIGURE 12. J2 Connector on the KP 812 Board
Comentarios a estos manuales