RTS TR-240 Especificaciones descargar pdf (Pagina 70)

Problem

The “Assoc” number on the BTR-240 does not

increment when a wireless TR-240 is booted

and communication does not happen.

Extremely loud static is heard on some or all of

the system devices.

Cannot login to the unit via telnet.

Possible Cause

• The TR-240 did not boot in wireless mode.

• The TR-240 is not in full-duplex.

• There is a network configuration problem.

• The audio encryption key on the devices do

not match.

• Login password was forgotten.

• There is a problem with the network

configuration on the computer that is trying

to telnet into the device.

Solution

• Review Section 6 of this manual and the

sub-section titled “Wireless Mode” for

instructions on how to boot the beltpack in

wireless mode. Ensure that the <TALK>

button is held down the whole time the unit

is booting.

• If the Channel button lights(s) on the

TR-240 are blinking, the TR-240 is in

half-duplex (listen-only) and the BTR-240

will not increment the “Assoc”. Review

Section 6 of this manual and the sub-section

titled “Talk Button” for instructions on how

to engage the microphone path and place

the TR-240 in full-duplex.

• Review Section 8 of this manual and the

sub-section titled “User Configuration”.

There are several potential sources for

network configuration error that will not

allow devices to communicate:

– IP addresses of units are the same

– SSID do not match

– Encryption is not enabled/disabled on all

devices.

– WEP encryption keys do not match.

– MAC address filtering (if enabled) has not

been configured properly and is blocking

the device.

• If the network configuration problem

cannot be identified, perform a Factory

Reset on all devices to restore all the

factory defaults. Review Section 5

(BTR-240) and Section 6 (TR-240) of this

manual for instructions on how to perform a

factory reset.

• Review Section 8 of this manual and the

sub-section “Display/edit audio encryption

key” for instructions on how to view and

modify the encryption key.

• Perform a Factory Reset on the device to

reset the password to the factory default.

Review Section 5 (BTR-240) and Section 6

(TR-240) of this manual for instructions on

how to perform a factory reset.

• Review Section 8 of this manual and the

sub-section titled “Network Configuration”

and ensure all instructions have been

followed.

12-2

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 85 86

Comentarios a estos manuales

Sin comentarios