RTS TR-240 Especificaciones Pagina 34
- Pagina / 86
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
e. Using the <UP>/<DOWN> buttons, find the desired
intercom type (off, Local, or Global) and press <SET>
to select.
The auxiliary output mode will stop flashing which
indicates that it has been set, and the intercom channels
will now flash indicating that they are ready to be
modified.
f. Using the <UP>/<DOWN> buttons, find the desired
intercom channels to activate. Press <SET> to activate
those channels and the LCD will go back to the Auxiliary
Menu Screen (return to Step 3).
To modify the Auxiliary Levels:
g. Using the <UP>/<DOWN> buttons, navigate the cursor
next to the menu option “Aux Levels” and press <SET> to
select the menu
The levels are displayed only for the active auxiliary
ports. If no auxiliary port is active, this menu option will
not be accessible.
h. Using the <UP>/<DOWN> buttons, navigate to the
desired level to modify and press <SET> to select it.
The corresponding cursor and level number will begin
flashing which indicates that the level can now be
modified.
i. Use the<UP>/<DOWN> buttons to move the bar level
up and down to the desired audio level and press <SET>
to select it.
j. At this point, the user has three options.
i. Press <SET> again to re-adjust the same level
(return to Step 4i).
ii. Use the <UP>/<DOWN> buttons to navigate to
another level to modify (return to Step 4h).
iii. Press the <MENU> button to go back to the
Auxiliary Menu Screen (return to Step 3).
iv. Press and hold the <MENU> button for 1/2 second
to return directly to the Status Screen.
4. When finished editing, from the Auxiliary Menu Screen, the
user has two options:
a. Press the <MENU> button to go back one menu screen
(return to Step 2).
b. Press and hold the <MENU> button for 1/2 second to
return directly to the Status Screen.
Speaker Output
The BTR-240 also features a speaker port in which the intercom
channels from the base station can be monitored. The speaker port
outputs balanced audio with a maximum output of 1W into 8
Ohms. As shown in Figure 5-35, the speaker port is a 2-pin
Phoenix type connector. Refer to Section 11 for the speaker
hardware specifications and pinouts.
Steps to change the Speaker Settings:
1. From the Status Screen, press <MENU> on the BTR-240
front panel.
2. Using the <UP>/<DOWN> buttons, navigate the cursor to
the “Speaker Settings” menu option, then press <SET> to
select the menu.
3. From the Speaker Menu Screen there are two selectable
options, “Spk Settings” and “Spk Level”.
The “Spk Settings” option will allow the user to select which
audio intercom channels are routed to the speaker port. The
“Spk Level” option will allow the user to change the output
level for the speaker port.
5-10
->Spk Settings
Spk Level
->Spk Settings
Spk Level
Figure 5-37
Speaker Menu Screen
-> Speaker Settings-> Speaker Settings
Intercom Settings Intercom Settings
Auxiliary Settings Auxiliary Settings
Prev.... Prev....
Figure 5-36
Main Menu Screen 2
Figure 5-35
Speaker Connector
PUSH
INPUT
BTR-240
Bosch Security Systems, Inc.
S.N. 00000
MADE IN USA
PROGRAM
10 26
TX
RX
SPEAKER
PUSH
2 WIRE
AUDIO
4 WIRE
INTERCOM 1
L
O
O
P
L
O
O
P
T
H
R
U
T
H
R
U
PUSH
2 WIRE
AUDIO
4 WIRE
INTERCOM 2
L
O
O
P
L
O
O
P
T
H
R
U
T
H
R
U
AUXILARY
OUTPUT
12/15/VDC
1.5A
IP: 192.168.1.1
BTR-240
Bosch Security Systems, Inc.
Illlll ll lllll lll lll llllllllllllllll llll lll llll lllll
Illllllll llllll llllllllllllll lllllllllll llll lllllllllll
Illlllllllllll llll llll lll llll lllll lll llllllllll lll
Illlll lllllllllll llll llllll ll llll lll llll lllll
Illlll lll lll ll lllllll
Illlllllll ll lll ll lllll lllllll
AUDIO
Speaker Connector
Aux OUT: GlobalAux OUT: Global
IC1: OFF IC2: ON IC1: OFF IC2: ON
Figure 5-33
Auxiliary Output Channel Settings Screen
Figure 5-34
Auxiliary Levels Screen
AuxOUT Level: 08 AuxOUT Level: 08
->AuxIN Level: 08->AuxIN Level: 08
- Operating Manual 1
- Thank you from Bosch 3
- Proprietary Notice 4
- Copyright Notice 4
- Disclaimer 4
- Table of Contents 5
- Section 1 - Introduction 9
- Important Safety Instructions 10
- AuxOut:1&2G 11
- AuxIn:1&2L 11
- RF Ch: 6 2W:1&2 11
- Assoc: 0 4W:1&2 11
- MADE IN USA 12
- Section 3 - TR-240 Beltpack 15
- Operating for the First Time 19
- Battery Charging Instructions 19
- Unpacking 19
- Beltclip Installation 20
- Antenna Connection 20
- Antenna Polarization 20
- Antenna Placement 20
- 24
- Section 5 - BTR-240 Operation 25
- Local Headset Interface 26
- 2-Wire Intercom 28
- TWO CHANNELS OF TELEX OR 29
- CLEAR-COM INTERCOM 29
- (from wired power supply) 29
- TO OTHER 2-WIRE EQUIPMENT 29
- 4-Wire (Matrix) Intercom 31
- Auxiliary Input/Output 32
- Speaker Connector 34
- SpeakerSpeaker 35
- AuxOut:1GAuxOut:1G 36
- AuxIn:OffAuxIn:Off 36
- Figure 5-47 38
- BTR-240 Menu Structure 38
- Section 6 - TR-240 Operation 39
- Mode of Operation 40
- Low Battery Indicator 41
- System Restore 42
- TR-24 beltpacks 42
- Section 7 - System Operation 43
- Wired Mode 44
- Wireless and Wired Mixed-Mode 44
- Master Wireless Mode 45
- TOUR GUIDE 46
- TOUR GROUP 46
- Cell-Type Architecture 47
- Multiple BTR-240s 48
- BTR-240s Linked via Ethernet 49
- BTR-240s Linked via 2-Wire 50
- BTR-240s Linked via 4-Wire 50
- Network Requirements 51
- User Configuration Options 53
- Computer Requirements 53
- Network Configuration 53
- Logging into a Device 54
- Software Version 55
- User Menu Options 56
- Channel Numbers 61
- Wired / Network Interference 64
- Telex Units 66
- RTS Units 66
- Auxiliary Output 67
- Speaker Output 67
- Section 12 - Troubleshooting 69
- Possible Cause 70
- Solution 70
- FCC and Industry Canada 73
- EU Compliance Information 74
- Table 13-1 75
- Table 13-2 76
- EU Declaration of Conformity 77
- Model Number 79
- Part Number 79
- Description 79
- Section 15 - Glossary 83
Relacionado con productos y manuales para Sistemas de intercomunicación de la puerta RTS TR-240
(18 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.037 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales