RTS TR-240 Especificaciones Pagina 20
- Pagina / 86
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
CHG-240 Quick Charge
Charging the batteries in the CHG-240 quick charger will only
require approximately 2½ hours to completely charge a dead
battery. Once charging is complete, batteries may be left charging
indefinitely.
NOTE: Review the instruction booklet for the CHG-240
quickcharger prior to use.
1. Ensure the TR-240 is in the “OFF” position and remove the
BP-240 battery pack.
2. Plug in the CHG-240 into a standard AC wall outlet.
Figure 4-3
CHG-240 Quick Charge
3. Insert the BP-240 battery pack into one of the bays on the
quick charger. The LED next to the battery bay indicates the
charge status.
YELLOW = Charging in progress
GREEN = Charging is done
4. Once the battery is completely charged, remove it from the
CHG-240 bay, install it back in a TR-240 beltpack and turn
the beltpack “ON” to resume operation.
Beltclip Installation
Install the beltclip by sliding it into the beltclip connector on the
back of the TR-240 beltpack. When inserted correctly, the
beltclip locking mechanism will “click” and the beltclip will not
be able to slide out.
Figure 4-4
Inserting Beltclip into TR-240 Beltpack
NOTE: To avoid scratching the TR-240 case, lift the metal tab
as the beltclip is inserted.
Antenna Connection
The BTR-24 base station is supplied with two (2) antennas for
transmitting and receiving. Both antennas are 3dBi
omni-directional (Model: RA-3) with reverse polarity TNC
connectors.
Attach one of the antennas to the transmitter antenna jack labeled
"TX" on the rear panel. The antenna should be vertically aligned.
Figure 4-5
Attaching Transmit Omni-directiona Antenna
Attach the second antenna to the receiver antenna jack labeled
"RX" on the rear panel. The antenna should also be vertically
aligned.
Figure 4-6
Attaching Receive Omni-directiona Antenna
Antenna Polarization
The supplied antennas are vertically polarized. This means that
both the transmitting and receiving antennas should operate in the
vertical position for the best performance.
Antenna Placement
Proper antenna placement has a significant effect on the overall
performance of the RTS Wireless Intercom System. The
following suggestions will help optimize system performance.
O
F
F
O
N
B
A
T
T
E
R
Y
B
A
T
T
E
R
Y
1
1
2
2
MI
C
MI
C
A
D
J
A
D
J
TA
LK
TA
LK
S
.
T
.
S
.
T
.
A
D
J
A
D
J
TR
-
2
4
0
TR
-
2
4
0
4-2
- Operating Manual 1
- Thank you from Bosch 3
- Proprietary Notice 4
- Copyright Notice 4
- Disclaimer 4
- Table of Contents 5
- Section 1 - Introduction 9
- Important Safety Instructions 10
- AuxOut:1&2G 11
- AuxIn:1&2L 11
- RF Ch: 6 2W:1&2 11
- Assoc: 0 4W:1&2 11
- MADE IN USA 12
- Section 3 - TR-240 Beltpack 15
- Operating for the First Time 19
- Battery Charging Instructions 19
- Unpacking 19
- Beltclip Installation 20
- Antenna Connection 20
- Antenna Polarization 20
- Antenna Placement 20
- 24
- Section 5 - BTR-240 Operation 25
- Local Headset Interface 26
- 2-Wire Intercom 28
- TWO CHANNELS OF TELEX OR 29
- CLEAR-COM INTERCOM 29
- (from wired power supply) 29
- TO OTHER 2-WIRE EQUIPMENT 29
- 4-Wire (Matrix) Intercom 31
- Auxiliary Input/Output 32
- Speaker Connector 34
- SpeakerSpeaker 35
- AuxOut:1GAuxOut:1G 36
- AuxIn:OffAuxIn:Off 36
- Figure 5-47 38
- BTR-240 Menu Structure 38
- Section 6 - TR-240 Operation 39
- Mode of Operation 40
- Low Battery Indicator 41
- System Restore 42
- TR-24 beltpacks 42
- Section 7 - System Operation 43
- Wired Mode 44
- Wireless and Wired Mixed-Mode 44
- Master Wireless Mode 45
- TOUR GUIDE 46
- TOUR GROUP 46
- Cell-Type Architecture 47
- Multiple BTR-240s 48
- BTR-240s Linked via Ethernet 49
- BTR-240s Linked via 2-Wire 50
- BTR-240s Linked via 4-Wire 50
- Network Requirements 51
- User Configuration Options 53
- Computer Requirements 53
- Network Configuration 53
- Logging into a Device 54
- Software Version 55
- User Menu Options 56
- Channel Numbers 61
- Wired / Network Interference 64
- Telex Units 66
- RTS Units 66
- Auxiliary Output 67
- Speaker Output 67
- Section 12 - Troubleshooting 69
- Possible Cause 70
- Solution 70
- FCC and Industry Canada 73
- EU Compliance Information 74
- Table 13-1 75
- Table 13-2 76
- EU Declaration of Conformity 77
- Model Number 79
- Part Number 79
- Description 79
- Section 15 - Glossary 83
Relacionado con productos y manuales para Sistemas de intercomunicación de la puerta RTS TR-240
(18 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.046 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales