RTS TR-240 Especificaciones descargar pdf (Pagina 51)

Network Requirements

These network requirements apply to interconnect BTR-240 base

stations and wired-mode TR-240 beltpacks. In general, the

BTR-240 and the TR-240 follow the same rules as other Ethernet

networked devices. These rules are:

1. All BTR-240 base stations and TR-240 beltpacks must have

a unique IP (internet protocol) address and cannot have the

same IP address.

Also, no other devices on the wired network can have the

same IP addresses as the BTR-240s or TR-240s being used.

2. Use category 5e (CAT5e) or better Ethernet cables that are

wired to standards T-568A or T-568B (most Ethernet cables

are built to these standards).

3. When connecting TR-240s or BTR-240s together directly

without the use of a building's network infrastructure, do not

use more than 100m (328ft) of Ethernet cable between

devices.

4. If using an existing building's Ethernet network, consult

your network administrator as to the locations you plan on

connecting your BTR-240s or TR-240s to the network. They

can then check to make sure distance limitations of the

network are met and that existing in-house routers / switches

are set to pass TR-240 and BTR-240 packets.

Description IP Type Destination IP Protocol

Audio 1 Multicast 239.192.168.1 UDP

Packet

Audio 2 Multicast 239.192.168.2 UDP

Packet

Audio 1 + 2 Multicast 239.192.168.3 UDP

Table 7-2

BTR-240/TR-240 Wired Data Packets

7-9

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 85 86

Sin comentarios

RTS TR-240 Especificaciones Pagina 51