4. Remember to save your changes if you want them retained for future use. See “SERVICE
MENU, SAVE CFG”, page 45.
7.5.14 MENUS, SERVICE, TEST PNL
TEST PNL lets you check operation of indicators and controls.
When you select TEST PNL, the following sequence will occur:
1. All alphanumeric displays will display % symbols to verify display operation.
2. All tricolor indicators will flash green-yellow-red-off. All single-color indicators will flash
green-off. This verifies the operation of all indicators displays.
3. The call waiting window will display TAP KEYS. If you tap any intercom key, the display
above that key will briefly display OK. If you rotate either the SELECT or VOLUME control,
the alphanumeric display above the control will increment or decrement by ones at each
detent. If you click the SELECT or VOLUME control, the call waiting window will display
OK. This verifies operation of all controls.
Double-click the SELECT control to return to the previous menu level. Or, press and hold the SE-
LECT control for about two seconds to exit menu mode.
7.5.15 MENUS, SERVICE, TONE
An internal tone generator may be turned on to check the audio path.
Click to select TONE, then rotate to select ON or OFF and click again.
☞
You can check the audio path to and from the keypanel by assigning a point-to-point key
assignment (with auto listen). When you activate the key, the tone should be audible.
Double-click the SELECT control to return to the previous menu level. Or, press and hold the SE-
LECT control for about two seconds to exit menu mode.
7.5.16 MENUS, SERVICE, USM (UNSWITCHED MICROPHONE, FOR KP-12 WITH
REAR CONNECTOR MODULE ONLY)
This menu serves two functions: it is used to provide a hot mic output to the intercom system, and
it is used to activate/deactivate microphone output to the MIC PRE OUT connector of the optional
Rear Connector Module.
1. Click to select USM.
2. Rotate the SELECT control to display either OUT ENBL (hot mic output to intercom system)
or PRE AMP (hot mic output to MIC PRE OUT connector). Then, click the SELECT control.
3. Rotate the SELECT control to select either ON or OFF, then click again.
Double-click the SELECT control to return to the previous menu level. Or, press and hold the SE-
LECT control for about two seconds to exit menu mode.
User Manual, DKP-8, DKP-12 and KP-12 Keypanels with Push-button Keys 47
(90 paginas)
(36 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales