1. All phone keys (including autodial or redial keys) must be off.
2. When you click on AUTODIAL, the call waiting window will display DIAL NUM.
3. If your phone system requires you to enter a digit to request an outside line, enter that digit
first. Some phone systems may also require a brief pause after the request for an outside line.
If this is the case, enter *99 after the first digit to create a pause.
4. Finish dialing the telephone number.
5. When finished dialing, click the SELECT control. The call waiting window will then display
TAP 0-9. Tap a single key (0 through 9) to assign the telephone number to autodial number 0
through 9.
6. After an autodial number has been assigned, the call waiting window will again display DIAL
NUM. Repeat steps 3 through 5 to store additional autodial numbers.
7. Press and hold the SELECT control for about two seconds to return to the top-level menu
when you are finished entering autodial numbers.
8. Use the SAVE CFG command, page
45, to store your changes. Otherwise, the autodial
numbers will be lost when the KP-12 is turned off.
7.3 MENUS, KEY ASGN
7.3.1 MENUS, KEY ASGN, GENERAL DESCRIPTION
The KEY ASGN menu provides greater flexibility than the top-level menu when assigning keys.
Also, this menu offers some additional types of key assignments not found on the top-level menu,
including phone keys.
7.3.2 MENUS, KEY ASGN, AUTODIAL (FOR KP-12 ONLY)
You use this menu item to assign a key to automatically dial a previously stored telephone number.
A TIF-951 Telephone Interface must be connected to the intercom system to use this feature.
☞
To store phone numbers for use by autodial keys, see “AUTODIAL MENU”, page 27.
1. When you click on AUTODIAL, the point-to-point scroll list will display for the currently
selected intercom system
1
.
2. Rotate the SELECT control to locate one of the two intercom ports to which the TIF-951 is
connected, then click SELECT. The call waiting window will display TAP KEY.
3. Tap the intercom key that you want to use as an autodial key. Next, ADL0 will display in the
call waiting window.
4. Rotate the SELECT control to select the desired autodial number (ADL0 through ADL9),
then click SELECT. The name ADL1, ADL2 etc. will appear in the display above the new
autodial key.
28 User Manual, DKP-8, DKP-12 and KP-12 Keypanels with Push-button Keys
1
If the intercom system is interconnected with other intercom systems, and the TIF-951 is
located in another intercom system, rotate the select control to display ICOM followed by the
desired intercom system name, then click SELECT. Wait for the point-to-point list to be
obtained from the selected intercom system.
(90 paginas)
(36 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales