7.5.11 MENUS, SERVICE, SET ADDR
SET ADDR must be used during installation or whenever the keypanel is reset or moved to a new
port.
Determining the Keypanel Address, CS9XXX Intercoms
For intercom port numbers ending in 1 through 9, the keypanel address is the last digit of the port
number. If the last digit of the port number is 0, use 10 as the keypanel address.
Determining the Keypanel Address, ADAM and ADAM CS Intercoms
Use Table
7, page 48.
Determining the Keypanel Address, Zeus Intercom Systems
The address is the number (1-8) printed next to the connector on the back panel of the Zeus Frame.
(This number repeats for each group of 8 connectors. The intercom system is able to distinguish
between two keypanels set to the same address by the group where each one is connected.)
Setting the Keypanel Address
1. While SET ADDR is displayed, click the SELECT control. ADDR 1 will appear in the call
waiting window.
2. Rotate the SELECT control to display the desired logical keypanel address (ADDR 1 through
ADDR 10) then click SELECT again. The new setting will automatically be saved, and after a
few moments, the alphanumeric displays will change from asterisks (
****
) to dashes (----).
Double-click the SELECT control to return to the previous menu level. Or, press and hold the SE-
LECT control for about two seconds to exit menu mode.
7.5.12 MENUS, SERVICE, SIDETONE
When you are using headphones that completely cover the ears, the sidetone feature lets you adjust
the level of your own voice in headphones to eliminate the muffled sensation when talking over
the intercom. This feature also adjusts the chime level. Activate a talk key, then click on SIDE-
TONE. Speak into the headset microphone while rotating the SELECT control to adjust your voice
level as desired.
Remember to save your changes if you want them retained for future use. See “SERVICE MENU,
SAVE CFG”, page
45
7.5.13 MENUS, SERVICE, TALLY
You can set the amount of time that the displays will flash for incoming calls as follows:
1. In the SERVICE menu, rotate the SELECT control to display TALLY, then click SELECT.
2. Rotate the SELECT control to display any of the following time periods (in seconds), then
click SELECT: 5 SEC, 10 SEC, 15 SEC, or EXTEND. If you select EXTEND, displays will
flash continuously for incoming calls until the calls are answered.
3. Double-click the SELECT control to return to the previous menu level. Or, press and hold the
SELECT control for about two seconds to exit menu mode.
46 User Manual, DKP-8, DKP-12 and KP-12 Keypanels with Push-button Keys
(90 paginas)
(36 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales