RTS XCP-48-RJ45 Manual de usuario descargar pdf (Pagina 21)

8. Double-tap the ENC1 knob to exit the threshold set menu item.

Port displays.

9. Turn the ENC1 knob to Hold Time.

10. Tap the ENC1 knob.

Hold Time appears.

11. Turn the ENC1 knob to set the hold time (up to 12.5 seconds).

NOTE: Hold time is the amount of time the VOX will stay active on a port before closing the port.

12. Double-tap the ENC1 knob to exit the Hold Time menu item.

Port displays

13. Turn the ENC1 knob to Enable.

14. Tap the ENC1 knob.

Enable appears. You can Enable or Disable from this point.

15. Double-tap the ENC1 knob to exit the Enable menu item.

NOTE: You can also set the VOX within AZedit. For more information about setting VOX in AZedit see

“Vox Settings in AZedit” on page 21.

Status Menu

The Status Menu displays settings for the following:

AZedit

Crosspoints

Frames

GPI Input

GPI Output

Keypanels

Links

NOTE: This chapter covers the menu display for the Master frame (Frame 1). On slave frames the only display you see

under Status menu is Links.

Status, AZedit

AZedit displays if there is an active connection.

NOTE: This only shows the status of the primary serial cable.

1. Turn the ENC1 knob to scroll to Status.

2. When Status is displayed, tap the ENC1 knob.

AZedit displays.

3. Tap the ENC1 knob

The status of AZedit appears.

OK = there is a connection to AZedit.

-- = there is no connection to AZedit.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 106 107

Sin comentarios

RTS XCP-48-RJ45 Manual de usuario Pagina 21