RTS XCP-48-RJ45 Especificaciones descargar pdf (Pagina 69)

Digi One, PortServer TS, and Multi-Port Serial Cards RJ-45 to DB-25M Printer

Adapter

90000611_A

Cable Adapters

Digi TS, RJ-45 to DB-25 Printer Adapter

For use with Digi One TS, Portserver TS 2/4/8/16, and Multi-Port Serial Cards with RJ45 connectors

Digi Cable Adapters allow you to connect your serial devices using commercially available CAT 5 cable of any length. Simply plug standard CAT 5

cable into your Digi Product, connect a Cable Adapter to the other end and plug the adapter into your device.

From

RJ-45

Signal Direction Signal To DB-

1 DCD RTS 4

2 RTS CTS 5

3 Ground Ground Shell

4 TxD RxD 3

5 RxD TxD 2

6 SG SG 7

7 CTS DTR 20

DSR 6 8 DTR

DCD 8

Pin 1 Pin 1

Female RJ-45 8-pin Male DB-25

Cable Adapter not to scale

* Arrows indicate which direction the signal is flowing

Notes:

 All RJ45 cable adapters are 8-pin.

 For use with Printers. This adapter utilizes the DTR signal of the serial device (instead of RTS) for hardware flow control (RTS/CTS)

 Okidata printers may use SSD (pin 11) instead of DTR (pin 20) on DB25 side of above diagram. If this is the case, the

printer should be set to SSD+.

 Altpin should be turned on when using this cable so that DTR will drive DCD (standard usage).

 If altpin is turned off, the hardware signal on RJ45 pin 1 becomes DSR instead of DCD. This alternative can be used if

DCD is not required, and DSR is needed instead.

Digi Part Number 76000692 Digi TS DB25M Printer Adapter (4-pack)

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 151 152

Sin comentarios

RTS XCP-48-RJ45 Especificaciones Pagina 69