RTS XCP-48-RJ45 Especificaciones descargar pdf (Pagina 152)

RJ-45 10 Pin to DB-25M Terminal Printer Cable

Cables

EIA-232 Terminal/Printer Cables, RJ-45 10-pin to DB-25

The wiring diagram for an RJ-45 10-pin to DB-25 terminal/printer cable is shown in Table 1.

Table 1: EIA-232 RJ-45 10-pin to DB-25 terminal/printer cable

From

RJ-45

Signal Direction Signal To DB-25

10 DCD

RTS 4

2 DSR

6 RxD

TxD 2

5 TxD

RxD 3

9 DTR

DSR 6

DCD 8

7SG

SG 7

3 RTS

CTS 5

8 CTS

DTR 20

4 GND

GND Shell

* Arrows indicate which direction the signal is flowing

This cable can also be purchased from Digi (see part number below).

● 4' RJ-45 10-pin to DB-25 - Part #76000238

NOTES:

●

Altpin should be turned off when using this cable.

●

This cable utilizes the DTR signal of the terminal/printer for hardware flow control (RTS/CTS).

●

Okidata printers may use SSD (pin 11) instead of DTR (pin 20) on DB25 side of above diagram. If

this is the case, the printer should be set to SSD+.

1 2 ... 147 148 149 150 151 152

Sin comentarios

RTS XCP-48-RJ45 Especificaciones Pagina 152