RTS XCP-48-RJ45 Especificaciones descargar pdf (Pagina 149)

RJ-45 to DB-25M Terminal Printer Cable

Terminal/Printer Cables

EIA-232 Terminal/Printer Cables, Altpin RJ-45 8-pin to DB-

The wiring diagram for an altpin RJ-45 8-pin to DB-25 terminal/printer cable is shown in Table 1.

Table 1: EIA-232 Altpin RJ-45 8-pin to DB-25 terminal/printer cable

From

RJ-45

Signal Direction Signal To DB-25

1 DSR RTS 4

5 RxD

TxD 2

4 TxD

RxD 3

8 DTR

DSR 6

DCD 8

6SG

SG 7

2 RTS

CTS 5

7 CTS

DTR 20

3 GND

GND Shell

* Arrows indicate which direction the signal is flowing

NOTES:

●

Altpin should be turned on when using this cable so that DTR will drive DCD (standard usage).

●

If altpin is turned off, the hardware signal on RJ45 pin 1 becomes DSR instead of DCD. This

alternative can be used if DCD is not required, and DSR is needed instead.

●

This cable utilizes the DTR signal of the terminal/printer for hardware flow control (RTS/CTS).

●

Okidata printers may use SSD (pin 11) instead of DTR (pin 20) on DB25 side of above diagram. If

this is the case, the printer should be set to SSD+.

1 2 ... 144 145 146 147 148 149 150 151 152

Sin comentarios

RTS XCP-48-RJ45 Especificaciones Pagina 149