RTS XCP-48-RJ45 Especificaciones Pagina 20

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 152
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 19
20 Chapter 5 EIA-232: DB-9
Terminal/Printer Cable for Software (XON/XOFF) or Hardware (RTS/CTS)
Handshaking
Note: Important: Other printer manufacturers may use different methods of
flow control. Consult your printer's documentation for specific wiring
requirements.
DB-9 Hardware Handshaking (RTS/CTS) Cable
The following cable is often sufficient for a terminal, printer, or other DTE
device configured for RTS/CTS (hardware) flow control. However, some
terminals and printers may have other cable requirements. Consult your
terminal or printer manual for this information. For more universal
compatibility, use a fully-wired DB-9 terminal/printer cable.
Terminal/Printer Cable with RTS/CTS Handshaking
DB-9
(Digi End)
DB-9 Male
(Terminal/Printer)
Signal Pin Pin Signal
DCD+DSR 1+6 connected to 4 DTR
RxD 2 connected to 3 TxD
TxD 3 connected to 2 RxD
DTR 4 connected to 1+6 DCD+DSR
SG 5 connected to 5 SG
RTS 7 connected to 8 CTS
CTS 8 connected to 7 RTS
GND Shell connected to Shell GND
DB-9 Female
(Digi End)
DB-9 Male
(Peripheral)
Signal Pin Pin Signal
RxD 2 connected to 3 TxD
TxD 3 connected to 2 RxD
SG 5 connected to 5 SG
RTS 7 connected to 8 CTS
CTS 8 connected to 7 RTS
GND Shell connected (via shield) to Shell GND
Vista de pagina 19
1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 151 152

Comentarios a estos manuales

Sin comentarios