RTS XCP-24 Manual de servicio Pagina 21

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 114
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 20
3-1
S ECTION
3
C
HAPTER
3
B
ASIC
O
PERATION
Screen Saver Operation
If the KP-632 is set for screen saver operation, the alphanumeric display automatically shuts off
after several minutes of inactivity. The display reactivates on incoming call or when the keypanel
operator actuates any control. DIP switch 3 turns enables/disables screen saver operation.
Note
You can override the normal timeout period for screen saver operation and immediately place the
keypanel in screen saver mode. See "Service Menu, Disply Dim".
Selecting Headset or Speaker
Tap the Headset / Vol. Sel. key downward. The Vol. Sel. display alternates between
Headset
and
Speaker
with each key tap. The Headset LED lights when the headset is selected and is off when
the speaker is selected.
Note
Future versions of ADAM Edit and Zeus Edit will be able to override the Headset or Speaker
setting.
Listen Volume Adjustments
By default, the Vol. control adjusts the listen volume for the speaker or headset, whichever
appears in the Vol. Sel. display. The level of auxiliary program inputs 1 & 2 (if GPI/O board is
present and Aux inputs are enabled) and the level of incoming audio from the intercom matrix can
be adjusted. To adjust a level, press the Vol. Sel. button until the desired source appears in the
Vol. Sel. display (
Aux1,
Aux2,
or
Icom
). Then, use the Vol. control to adjust the listen volume. The
Vol. control defaults back to the speaker or headset after about one minute of inactivity of the
control. The minimum volume level for either the keypanel speaker or headset may be adjusted.
See “Service Menu, Min Volume”.
Note
You can save the volume adjustments to be the power-up defaults using "Service Menu, Save
Cfg".
Vista de pagina 20
1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 113 114

Comentarios a estos manuales

Sin comentarios