RTS WM300 Especificaciones Pagina 60

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 67
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 59
Chapter 2 Specification of Communication port for CPU module
2 – 46
2.3.4 Modem connection function
EHV-CPU is equipped with a model connection function. The model connection function can be controlled using
task codes. The setup on the Control Editor is needed to use this function.
Refer to the following table for communication specifications.
If a difference of communication speed between two operating modems, connecting between them may be difficult.
Therefore, please combine to eliminate any difference in communication speeds.
(1) Configuration
Modem Modem
RS-232C
(MAX 57.6 kbps)
Commercial line
EHV-CPU PC
Figure 2.38 Connection configuration of modem
(2) Specifications
Table 2.25 Specification for Modem connection function
Item Specification
Communication speed 2,400 bps4,800 bps9,600 bps19,200 bps38,400 bps57,600 bps
Communication system Full duplex system (Communication program is half-duplex control.
Synchronization system Start-stop synchronization system
Transmission system Serial transmission (Bit serial transmission)
Transmission code ASCII code
Transmission code
configuration
2
0
2
1
2
6
P
Stop bit (1 bit)
Parity bit (1 bit) Start bit (1 bit)
Data (7-bit)
(Even-numbered parity)
Transmission code
outgoing sequence
out from the lowest bit (20) in character units.
Error detection Vertical parity check, Overrun check, Framing check
Interface Conforms to RS-232C
Control procedure H-series dedicated procedure (High protocol)
Startup system One-side startup system by the host side command
Time out detection at
connecting modem
Sets by Control Editor
Time out detection at
communicating modem
Sets by Control Editor
* ER signal cannot be controlled. Therefore, the line is cut by commands or control by connecting the line is
needed using other I/O.
Vista de pagina 59
1 2 ... 55 56 57 58 59 60 61 62 63 64 65 66 67

Comentarios a estos manuales

Sin comentarios