RTS XCP-40-RJ11 Guía de instalación descargar pdf (Pagina 31)

Connecting to the SSA-324

Rear Panel

Switches

Unbalance (Out) Balance (In) / Select Two-wire, System A

Unbalance (Out) Balance (In) / Select Two-wire, System B

Operation Nulling

Preset Controls as follows:

To/From RTS Set to Midway

Duck Level Set to CW

Low Set to Midway

Med Set to Midway

Hi Set to CW

Volume 10 o’clock

Press Test Switch

1. If test signal tone, adjust Med for null, then Hi, then Low. If test signal voice, say “ahhhhh” into microphone, adjust Med

for null, then Hi, then Low.

2. Release Test Switch

Level Setting

1. Have Talkers 1 and 2 on 4-wire system, Talkers 3 and 4 on 2-wire system. Adjust To / From RTS Controls so that all

Talkers can hear each other at about the same level regardless of which system they are on.

Duck Setting

1. Adjust Duck Level only if full duplex operation is not possible because of feedback. Adjust Duck Level carefully from CW

towards CWW. Only a very small amount of ducking should be used.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 57 58

Sin comentarios

RTS XCP-40-RJ11 Guía de instalación Pagina 31