RTS RVON-I/O Manual de usuario descargar pdf (Pagina 32)

26

Examples:

Set RVON ip_addr to 10.3.210.12.

> At the command prompt, type

set rvon ip_addr 10.3.210.12

Set the destination channel type to RVON-I/O.

> At the command prompt, type:

set channel [chan_dest num_type 2

set channel

[chan]

onhook force the channel to disconnect.

set channel

[chan]

offhook force the channel to connect.

set serial

Help screen, which lists all “set serial”

commands.

set serial mode X

Set the serial mode.

0 = Pass Through mode

set serial ip_addr X.X.X.X

Set the destination IP Address for this serial

pass-through port.

set serial ip_addr_2 X.X.X.X Not Available

set serial baud X

Set the baud rate to use:

50 through 115000.

set gpio

Help screen, which lists all “set gpio”

commands.

set gpio mode X

Set the gpio mode.

0 = Pass Through

1 = 1 Keypanel

2 = All Keypanels

set gpio ip_addr X.X.X.X

Set the destination IP Address for pass-

through mode.

set gpio panel X

Set the IO port the gpio are associated with

on the RVON-I/O.

set panel

Help screen, which lists all “set panel”

commands.

set panel

[pnl]

poll_id X

Make sure the panel poll_id corresponds to

the source of the audio it is connected to.

0-10

0= do not respond to polls

set panel

[pnl]

baud X

Set the baud rate for the panel.

9600 or 76800

TABLE 10. RVON-I/O Command Table

Command Parameter 1 Parameter 2 Description

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 59 60

Comentarios a estos manuales

Sin comentarios