RTS ICP-2000 Manual de usuario descargar pdf (Pagina 43)

RVON-8 Default Setup

Every attempt is made to ensure the board is shipped from the factory containing the following:

All are “set rvon” commands

There are more parameters that the software will auto-configure if they have not been previously setup. The user can also set

these parameters, in which case the software would not modify but take them as they are.

activate

Must do an activate command to cause changes

to take effect.

show rvon Display current settings

show channel

[chan]

Display current settings

show emac Display current settings

VARIABLE ENVIRONMENT NAME DEFAULT

VA L U E

DESCRIPTION

ip_addr EMACA_IPADDR 192.168.0.1 IP Address for the RVON-8 Card

netmask EMACA_NETMASK 255.255.255.0 Network Mask for the RVON08 card

gateway EMACA_GW none Gateway IP Address for the RVON-8 Card

serial_ip RVON_SERIAL_IP none Pass-thru serial port IP Address for the RVON-8

Card

serial_baud RVON_SERIAL_ Baud 9600 Set the pass-thru serial port baud rate for the

RVON-8 Card

user RVON_USER telex RVON-8 user name for telnet access

password RVON_PASSWORD password RVON-8 password for telnet access (8-40

characters)

vad_threshold RVON_THRESHOLD_VAD adaptive VAD Threshold

TABLE 5. RVON-8 Command Table

Command Variable 1 Variable 2 Description

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 54 55

Sin comentarios

RTS ICP-2000 Manual de usuario Pagina 43