RTS DV-3400 Información técnica descargar pdf (Pagina 459)

100

101

File Transfers

Copying Diagnostic Data to a Remote Host, PC, or UNIX Workstation

Copying Diagnostic Data to a Remote

Host, PC, or UNIX Workstation

You can use the CLI to copy the following types of switch data to a text file in

a management device:

■ Command Output: Sends the output of a switch CLI command as a file on

the destination device.

■ Event Log: Copies the switch’s Event Log into a file on the destination

device.

■ Crash Data: software-specific data useful for determining the reason for

a system crash.

■ Crash Log: Processor-Specific operating data useful for determining the

reason for a system crash.

Copying Command Output to a Destination Device

Syntax:

copy command-output < “cli-command” > tftp < ip-address > < filepath-

filename >

copy command-output <“cli-command”> xmodem

These commands direct the displayed output of a CLI

command to a file in a destination device.

For example, to use Xmodem to copy the output of show config to a serially

connected PC:

At this point, press

[Enter] and start the

Xmodem command

sequence in your

terminal emulator.

Indicates the operation is finished.

Figure A-10. Example of Sending Command Output to a File on an Attached PC

Note that the command you specify must be enclosed in double-quote marks.

A-29

1 2 ... 454 455 456 457 458 459 460 461 462 463 464 ... 579 580

Comentarios a estos manuales

Sin comentarios

RTS DV-3400 Información técnica Pagina 459

Comentarios a estos manuales