Rts Digital Matrix Intercom RT-2M Manual de usuario descargar pdf

RT-2M (90007891000) Quick Start Guide

NOTE: See the entire system diagram on reverse side.

RS-232 Cable Pinout

Step 1. Cable the Trunk Supervisor/TrunkEdit PC to the

RT-2M.

NOTE: In Trunk Supervisor, you must designate

the intercom and port number the RT-2M

sends the test signal over.

To cable the Trunk Supervisor/TrunkEdit PC to the

RT-2M, do the following:

1. Using the included cable, connect a COM port on

the Trunk Supervisor computer to the RS-232

Interface connector on the rear panel of the RT-2M.

Step 2. Cable the RT-2M to the Frame.

To cable the RT-2M to the Frame, do the following:

1. Using the appropriate connector defined below, connect the

RT-2M to the Frame:

2. Connect the other end of the connector to the trunking

connection port as defined in the Trunk Supervisor software.

CONNECTOR CONNECTION

RJ-12

• Plug pins 2 and 5 into the Ch 1 input connector terminals.

• Plug pins 3 and 4 into the Ch 1 output connector terminals.

DB-9

• Plug pins 7 and 8 into the Ch 1 input connector terminals

• Plug pins 4 and 5 into the Ch 1output connector terminals.

INCLUDED PARTS:

• RT-2M Unit

• DB-9 Cable

LIT000306000 Rev. A 11/2008

1 2

Indice de contenidos

Pagina 1

RT-2M (90007891000) Quick Start GuideNOTE: See the entire system diagram on reverse side.RS-232 Cable PinoutStep 1. Cable the Trunk Supervisor/TrunkEd

Pagina 2

Comentarios a estos manuales

Sin comentarios

Rts Digital Matrix Intercom RT-2M Manual de usuario

Busca en linea o descarga Manual de usuario para Hardware Rts Digital Matrix Intercom RT-2M. RTS Digital Matrix Intercom RT-2M User Manual Manual de usuario

Indice de contenidos

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Rts Digital Matrix Intercom RT-2M