RTS XCP-ADAM-MC Guía de instalación descargar pdf (Pagina 10)

Pressing a PL4 key will activate its talk/listen assignment,

and at the same time, it will disable the PL1 through PL3

keys directly above it. When the ISO key is turned off,

the previous state of the other three keys will be restored.

This ISO feature is selectable using an internal DIP

switch in the CDP-950.

The following procedures describe the installation and

programming of the CDP-950 for use in an ADAM inter-

com system:

10.8.3 Installing the CDP-950

1. Before installing the CDP-950, remove the top cover

and set the internal DIP switches.

• DIP switch #1: Normal / ISO select

Closed: normal operation

Open: ISO operation

• DIP switch #2: Baud rate select

Closed: 9600 baud

Open: 76,800 baud (do not use for ADAM)

• DIP switch #3: Not used (position does not matter)

• DIP switches 4 thru 8: Intercom range select

(see Table 4, page 11 for settings.)

2. Connect the CDP-950 to the data pins for any one of the

intercom ports that will be controlled. Several possi-

ble cable wiring diagrams are shown in the ADAM-

811 drawing, page 38.

3. Connect belt packs, camera intercoms etc. to the audio

input and output pins of each intercom port control-

led by the CDP-950.

10.8.4 Programming the CDP-950

Run the CSedit program and assign the CDP-950 keys

just as you would normal keypanel keys. (See “Key Panel

Setup and Trunking Port Allocation” in Section 2 of the

CSedit User Manual.) For each intercom port, the PL1

through PL4 keys on the CDP-950 correspond to keys 12

through 15 in the CSedit key assignment table. Note:

when a key is activated, both the talk and listen assign-

ment for that key will activate.

8 ADAM Installation Manual

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 40 41

Sin comentarios

RTS XCP-ADAM-MC Guía de instalación Pagina 10