RTS XCP-48-RJ45 Manual de usuario descargar pdf (Pagina 21)

Cronus Menu System Introduction

Status, GPI Output

GPI Output status displays the status of each GPI Output assigned in the system. GPI output is similar to the GPI Input, except

instead of triggering an action on the intercom, the intercom is programmed to perform a function as a result of an action on

the intercom. For example, when a port is connected to a 2-way radio, the radio is normally in receive mode. Use a GPI Output

to trigger the transmitter whenever anyone talks to the port.

1. Turn the ENC1 knob to scroll to Status.

2. When Status is displayed, tap the ENC1 knob.

AZedit displays.

3. Turn the ENC1 knob to scroll to GPI Output.

4. Tap the ENC1 knob.

1-64 displays.

5. Turn the ENC1 knob to scroll through the GPI Output assignments.

For more information, see the AZedit User Manual.

Status, Keypanels

The Keypanel status menu displays the status of each of the keypanels in the Cronus system.

1. Turn the ENC1 knob to scroll to Status.

2. When Status is displayed, tap the ENC1 knob.

AZedit displays.

3. Turn the ENC1 knob to scroll to Keypanels.

4. Tap the ENC1 knob.

The status is shown for keypanels 1 & 2.

5. Turn the encoders to display the status of the other keypanels (up to 32 keypanels per frame.

The status will display as OK or blank.

Status, Links

The Links status menu displays the status of the links (connections) between frames, see “Cronus System Diagram and Frame

Cabling” on page 9. Each frame in the system has two links, Link A and Link B. Link A on each frame connects to the preced-

ing frame (connecting to Link B).

1. Turn the ENC1 knob to scroll to Status.

2. When Status is displayed, tap the ENC1 knob.

AZedit displays.

3. Turn the ENC1 knob and scroll to Links.

4. Tap the ENC1 knob.

5. Turn the ENC1 knob to scroll through the Links.

You should check the status of the Frame Clock and the Link to each frame. This is good for diagnostic troubleshooting.

NOTE: Frame 1 (Master) will only show the Frame 2 status because it only connects to one other Cronus frame.

Version, Intercom

The Version, Intercom menu, displays the firmware version that is current on the intercom.

NOTE: For Firmware upgrades, contact Telex Customer Service. The Cronus Firmware can be upgraded through AZedit. See

page “Download Firmware for Cronus” on page 24, for more information.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 53 54

Sin comentarios

RTS XCP-48-RJ45 Manual de usuario Pagina 21