RTS ICP-2000 Manual de usuario descargar pdf (Pagina 41)

0000002746 − NMM: 7, states: oper=NORMAL, admin=NORMAL, call=IDLE

0000002746 − RVON: port 0, now idle

0000002746 − RVON: port 1, now idle

0000002746 − RVON: port 2, now idle

0000002746 − RVON: port 3, now idle

0000002746 − RVON: port 4, now idle

0000002746 − RVON: port 5, now idle

0000002746 − RVON: port 6, now idle

0000002746 − RVON: port 7, now idle

0000003037 − CBTX: MC/DBX is talking

0000003041 − FNRX: control bus FIFO now enabled

0000003093 − FNRX: new card configuration received

Following the power-ON messages, press Return.

The -> appears. This is the operating system prompt.

There are many different serial port commands support from here, but is NOT recommended that any be used EXCEPT:

d/jointfilesconvert/370447/bgcmd

Type “d/jointfilesconvert/370447/bgcmd”, then press Return.

This places the serial port into the MXP> (MXP command mode)

The MXP Command Mode is the only mode that will be used. Table 1 is a list of commands support from the MXP Shell

Prompt.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 54 55

Sin comentarios

RTS ICP-2000 Manual de usuario Pagina 41