RTS BP-325 Manual de usuario

9350-5690-00 Rev. M 8/2008IIIMODEL BP-325Belt-pack Intercom StationUser Manual

CONNECTIONS AND OPERATION6FIGURE 1. LINE INPUT Connector Wiring for 1-Channel Operation with Non-RTS Power SupplyFIGURE 2. Bottom View of the Main Cir

CONNECTIONS AND OPERATION7METHOD TWO: TWO CHANNEL OPERATION WITH A NON-RTS POWER SUPPLY1. Referring to Figure 1, remove all three screws (10a and 10b)

CONNECTIONS AND OPERATION8

9CHAPTER 2REPLACEMENT PARTSWHERE TO OBTAIN PARTSParts may be obtained directly from RTS at:TELEX/RTS SYSTEMSAttn: Factory Service8601 East Cornhusker

REPLACEMENT PARTS10MECHANICAL PARTSFinal Assembly(Refer to Figure 5, “Final Assembly, BP325,” on page 21 drawing for Item No. locations)Item No. Qty D

REPLACEMENT PARTS11ELECTRICAL PARTSITEM QTY REF PART NUMBER VALUE19C12,C22,C23,C24,C26, C30,C31,C32,C461099R2263GT 22UF2 1 C41 1502R2284E 2200U

REPLACEMENT PARTS12

15CHAPTER 3Specifications and DrawingsSpecificationsDimensions5.00” High x 3.75” Wide x 2.05” Deep(127mm x 96.3mm x 52.1mm)Weight0.5 pounds (225 grams

Specifications and Drawings16DrawingsDrawing Number Title9030-6634-000 Front Panel Circuit Board Assemblyt9030-6635-000 Main Board Layout9020-6736-000

17Figure 1: Front Panel Board Assembly, BP325

PROPRIETARY NOTICEThe product information and design disclosed herein were originated by and are the property of Telex Communications, Inc. Telex rese

18Figure 2: Main Board, BP325

19Figure 3: Rear Panel Assembly, BP325

20Figure 4: Front/Top Panel Assembly, BP325

21Figure 5: Final Assembly, BP325

22Figure 6: Schematic, Main Board page 1

23Figure 7: Schematic, Main Circuit Board page 2

24Figure 8: BP-325 Cable Assemblies

TableOfContentsChapter 1 - Connections And OperationConnections ...

1CHAPTER 1CONNECTIONS AND OPERATIONThis section describes operation of the BP325 as supplied from the factory. Use of an RTS power supply to power the

CONNECTIONS AND OPERATION2OPERATION1. Attach the BP325 to your belt or other convenient location using the belt clip on the rear panel.2. Put on the h

3FACTORY SETTINGSa.When there is an incoming call on a channel, the red call LED will flash.b.If a talk LED is also flashing, this indicates that you

CONNECTIONS AND OPERATION4Jumpers (W1-W7)No. Setting DescriptionFactory DefaultW1CH 1 Intercom Audio Listenaa. Listen is factory set to be ON all the

CONNECTIONS AND OPERATION5SIDETONE ADJUSTMENTYou can change the level of your own voice heard in your headphones while talking on an intercom channel.